The Redarc In-Vehicle BCDC Battery Charger - Dual Input part # 331-BCDC1250D is only compatible with unregulated 12V nominal solar panels. You can use 2- 12 volt solar panels in series. The solar input voltage must not exceed 32V. I have attached a snip from the instructions for your reference. view full answer...
To plug your SmartPlug RV Power Cord and Stainless Steel Inlet # SM39FR into your home you can either install a 30amp outlet which would have slanted prong receptacles like the plug pictured below or you can use the Mighty Cord RV Power Cord Adapter # A10-1530HVP to plug into your standard outlet.
This adapter isn't going to give you full power for your RV since you'd be pulling from a 15amp source. If you're wanting to receive 30amps you'll have to install a 30amp outlet, which can be... view full answer...
There is a fit for SumoSprings on your RV so long as your Sprinter motorhome is a 2017 Mercedes-Benz Sprinter 3500 with two-wheel drive. If that is the case the correct fit is the following:
- SumoSprings Solo Custom Helper Springs - Rear Axle # SSR-338-54
- SumoSprings Solo Custom Helper Springs - Front Axle # SSF-106-40
These will do a fantastic job of helping minimize sway and body roll to give you a more comfortable ride in your motorhome. I have added a link below to a video review... view full answer...
We actually have the Hollywood Racks Destination E Bike Rack for 2 Electric Bikes # HLY66ZR in our demo area so I opened the clamp as far as I could and took some measurements. The clamp has a U shape and from the opening to roughly 3/4 of the way to the center it measures 3" wide and then slims down to 2" wide. view full answer...
For a spare carrier that can carry a dually wheel and tire you'd want the part # RM-195225 which we've confirmed works with dually wheels. As long as your door is more than 12-1/8 inches above the top of the hitch opening when opening this would allow the door to open when the rack is swung down. view full answer...
I spoke with Roadmaster to ensure the Roadmaster Rear Anti-Sway Bar Item # RM-1209-120 would be a confirmed fit with your 2018 Mercedes-Benz Sprinter 3500 dually and they have confirmed it will work. view full answer...
The GearDeck 17 Enclosed Cargo Carrier part # H00604 measures about 33" from the top of the shank to the top of the carrier. I don't have any specific compatibility info with your Fiamma Bike Carrier but all you need to do is measure from the top inside edge of your receiver tube on the trailer hitch to the bottom of the tray for the bike rack while folded down. If you have at least 33" then the GearDeck 17 Enclosed Cargo Carrier will work for you.
The Yakima Swinging Enclosed Cargo Carrier... view full answer...
Yes, the SumoSprings Solo Custom Helper Springs part # SSR-338-47 will fit a 2021 Winnebago View on Mercedes-Benz Sprinter VS30 Chassis. view full answer...
Low-profile Class S tire chains like the Konig Low-Pro # TH04115255 are designed for vehicles with limited clearance in the wheel wells. These are also perhaps the easiest-to-use tire chains on the market, as you can see in the linked video, since they include features such as automatic tension control, quick-release and vehicle rim protection. Installation is simple, as noted in the linked diagram.
Class U chains are for vehicles with more wheel well clearance. If your owners manual calls... view full answer...
The only option we have for a spare tire carrier for your Class C motorhome that will fit a 16 inch dually spare is a hitch-mounted carrier:
Roadmaster Hitch Mounted Spare Tire Carrier # RM-195225
This fits 16 - 24-1/2 inch wheels that have any bolt hole pattern. view full answer...
Installing the Roadmaster Rear Anti-Sway Bar # RM-1209-131 will not void your warranty. Stuff like this is protected under the Magnuson-Moss warranty act. This states that unless the part added actually causes a problem, then installation and use of the part will not void the warranty.
That said, the correct sway bar will depend on your vehicle. I see you entered a 2020 Mercedes-Benz Sprinter 3500 and there are two options available for this vehicle. I have both listed below.
Cargo Van... view full answer...
You can use rivet-mounted tracks to install a Rhino-Rack roof rack on your 2020 Winnebago View 24V motorhome, I'd just recommend paying special attention to sealing the roof where the rivets are. What you need first are the tracks, and with such a long roof, you can pick the length that works for you:
- Rhino-Rack RT-Style Roof Rack Tracks - Rivet Mount - 39-3/16" Long # RRRTS534
- Rhino-Rack RT-Style Roof Rack Tracks - Rivet Mount - 58-1/2" Long # RTS502
- Rhino-Rack RT-Style Roof Rack... view full answer...
You can use the Ultra-Fab Deluxe Electric Landing Gear Set # UF17-943010 on your Class A motorhome. As long as you have the room to install, clearance, and don't exceed the 12,000 lb capacity you won't have an issue. view full answer...
I do have options for you but the custom fit trailer hitches that you were looking at like the Curt Trailer Hitch Receiver part # 13375 for a 2018 Mercedes-Benz Sprinter 3500 are not designed for the cab and chassis models like you have. Therefore, I cannot confirm they will work for you.
Instead, I recommend taking a look at the Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver part # 41990-07 which can accommodate many different types of RV chassez. The brackets can be cut to... view full answer...
The Blue Ox High-Low Adapter for Tow Bars part # BX88131 is designed for flat towing a vehicle behind a motor home so there is not a tongue weight capacity since the vehicle is supporting itself on all 4 wheels. If you are using this for flat towing a vehicle the overall capacity of the adapter is 5,000 lbs.
It sounds like you may be towing a trailer and need a ball mount with 8" of rise/drop. The closest option available to the Blue Ox High-Low Adapter is Curt Ball Mount part # C45090... view full answer...
The Hitch Extender # HE06 reduces receiver capacity by 50%. To carry your 51.6lb e-bikes on the Thule EasyFold XT Bike Rack # TH903202 which weighs 45lbs your receiver must be able to support up to 296.4lbs since the bikes with carrier weigh 148.2lbs loaded. This should be well below the receivers weight capacity but you should verify this with your receiver manufacturer. view full answer...
The top of the line and by far the best supplemental braking system is going to be the Demco SBS Stay-IN-Play DUO Supplemental Braking System item # SM99251. This is a proportional braking system which is permanently installed. The Stay-IN-Play uses an inertia sensor to detect when you decelerate which in turn will activate your Mini's brakes. This system is made in the USA and comes with a 5 year warranty.
I've added links to a couple of video reviews for you to take a look at.
Some... view full answer...
Attaching the EcoHitch Hidden Front Hitch item # 306-X7352 not your 2022 Sprinter 3500 will not affect the warranty. This hitch is custom fit and bolts to your Mercedes with included hardware.
This front mounted hitch has a 3,500 lbs capacity for mounting accessories and a 500 lbs gross trailer weight. The 2" x 2" receiver sticks out at the bottom of the front bumper and does not effect your ground clearance.
Consumers are protected under the Magnuson–Moss Warranty Act. It allows aftermarket... view full answer...
You were definitely on the right track looking at SumoSprings, but the fit is going to depend on whether or not you have a 2WD or 4WD Sprinter.
For 2WD you'd need part # SSR-338-54 for the rear and part # SSF-106-47 for the front.
For 4WD you'd need part # SSR-339-47-2 for the rear and part # SSF-327-47 for the front.
All of these springs are made to easily install with no drilling required and are completely maintenance free. I've attached some videos below to help walk you through... view full answer...
Go To Results